| Below is a list of the rivets sizes specified in the RV-10 that I changed. | |||||
| Make sure you check the rivet lengths to make sure they are correct. | |||||
| Vertical Stabilizer | |||||
| Page | Step | Per Plans | What I Used | Quantity | Location |
| 6-4 | 7 | AN426AD4-7 | AN426AD4-8 | 6 | VS-1007 middle inspar rib and VS-1010 bottom rudder hinge bracket |
| 6-5 | 3 | AN470AD4-4 | AN470AD4-4.5 | 3 | VS-1013 to VS-1002 to VS-1007 |
| Rudder | |||||
| Page | Step | Per Plans | What I Used | Quantity | Location |
| 7-7 | 3 | AN470AD4-6 | AN470AD4-6.5 | 3 | K1000-6 nut plate to R-608PP to R-1002 |
| Horizontal Stabilizer | |||||
| Page | Step | Per Plans | What I Used | Quantity | Location |
| 8-11 | 3 | AN470AD4-4 | AN470AD4-4.5 | 6 | HS-904 to front spar assembly (2 places, 3 each) |
| 8-11 | 3 | AN470AD4-4 | AN470AD4-4.5 | 12 | HS-1004 to front spar assembly (6 places, 2 each) |
| 8-11 | 3 | AN470AD4-5 | AN470AD4-5.5 | 12 | HS-1004 to front spar assembly (6 places, 2 each) |
| 8-13 | 1 | LP4-3 | AN470AD4-4.5 | 6 | HS-904 to front spar. This step was completed during the step on page 8-11 step 3 |
| 8-13 | 6 | AN470AD4-4 | AN470AD4-4.5 | 6 | HS-904 outer rib to rear spar assembly (2 places, 3 each) |
| 8-13 | 6 | AN470AD4-6 | AN470AD4-7 | 6 | Inboard rib to rear spar assembly (2 places, 3 each) |
| Elevators | |||||
| Page | Step | Per Plans | What I Used | Quantity | Location |
| 9-10 | 2 | AN470AD4-4 | AN470AD4-4.5 | many | All common 1/8" holes of E-903 & 904 except the 2-426 rivets |
| 9-10 | 7 | AN470AD4-4 | AN470AD4-4.5 | 24 | Elevator horns to front spar and root ribs |
| 9-14 | 6 | AN470AD4-4 | AN470AD4-4.5 | 8 | Tip rib assembly to E-1002 (2 places, 4 each) |
| 9-15 | 7 | LP4-3 | AN470AD4-4.5 | 8 | WD-415 to E-616 (2 places, 4 each) |
| Tailcone | |||||
| Page | Step | Per Plans | What I Used | Quantity | Location |
| 10-21 | 2 | AN470AD4-4 | AN470AD4-4.5 | 37 | F-1029 R&L to F-1037 B&C |
| 10-25 | - | AN426AD3-4 | AN426AD3-4.5 | 3 | Side skin to bottom of rear bottom skin |