RV-10 N205EN

Up one level RV-10 Construction » Construction Log » Wings

Wings
Wing tips are complete. I ordered in March 2005 and Van's had an August ship date. However, in typical Van's fashion the quickbuild wings and fuselage shipped in early July. I am using Partain Transport Company (518/330-0828) to do the shipping. Not a significant cost savings since I live in New Jersey, but it should be more convenient.

Unload
Unloading & Inventory  |  Total images: 16
Ordered in March 2005 and Van's had an August ship date. However, in typical Van's fashion the quickbuild wings and fuselage shipped in early July. I am using Partain Transport Company (518/330-0828) to do the shipping. Not a significant cost savings since I live in New Jersey, but it should be more convenient.
GapFairing
Gap Fairing - Starting Work on the wing  |  Total images: 15
Got back from Oshkosh and started work on the wing.
Stall
Stall Warning Access Panel  |  Total images: 2
Installation of the stall warning access panel.
PushRods
Push Rods  |  Total images: 4
Put together the push rods for the wings and fuselage all at one time.
RollServo
Wing Roll Servo (TruTrak)  |  Total images: 14
Installation of the TruTrak roll servo in the right wing
FuelLevel
Fuel Level Sensor  |  Total images: 2

I installed the fuel level sensors in both wings. It was time consuming to get the floats to obtain full travel.

This is how I installed the fuel senders into my quickbuild wings:

  • I bend the rod per the plans.
  • I attached safety wire to the rod
  • The safety wire was fished through the bottom drain opening (VA-112)
  • I connected a multimeter to the fuel sender and measured the resistance through the range of the fuel sender using the safety wire to move the float up and down.
  • I would shine a flash light through the finger strainer (VA-141) on the inboard side of the wing and try to look through the drain opening with the safety wire to see where the float was hitting.
  • Then remove the fuel sender, tweak / rebend the rod, re-install and check the range of motion with the multimeter.
  • Do this over and over again until you get the full range from the float
In the end I got resistance reading of:
Right tank:  empty 247 ohms, full 29 ohms.
Left tank: empty 246 ohms, full 33 ohms.
AileronTrim
Aileron Trim (Optional Vans Kit)  |  Total images: 3
Straight forward installation of the Aleron Trim kit
Tips
Wing Tips & Lights  |  Total images: 33
Installation the wing tips, nav lights & strobe, Vans landing light kit, and Archer nav antennas. Two nav antennas, one in the right wing tip and one in the left.
Gretzmount
Gretzmount  |  Total images: 8